Electric Ceiling Hoist

How to correct the installation of the Electric Ceiling Hoist slide wire？

1. Electric Ceiling Hoist is installed on the u-shaped track. For this characteristic, in the middle of the track we will arrange the cable, the upper part of the i-steel. The wire rope is used for a 10mm steel wire rope or round steel, and the end is fastened with a basket bolt. The wire rope is used for a 10mm steel wire rope or round steel, and the end is fastened with a basket bolt.
2. The sliding ring is held by two rings, with a certain margin to avoid the cable scratches. The two rings are bolted to the ring and can rotate freely.
3. One end of the steering ring is set on the wire rope, and the rubber sleeve is fixed to the lower end of the steering ring after the motor leads. Then, one end of a plurality of slip rings is worn on the steel wire, and then the rubber sleeve line is fixed at the lower end of the sliding ring in a sectional way. The front end is connected with the motor and can rotate freely. The back end is connected with the power supply.
4. In the traction motor, the steering ring as the center, traction rope straight or circular motion.
5. The Electric Ceiling Hoist straight track can also adopt the above method.